How do you set a stone in metal clay?
Create an indentation in the Silver Clay, for your gemstone, before firing. Then glue the stone into place, once your metal clay design is fired, polish and complete. Don’t forget that metal clay shrinks during firing, so be sure to make the indentation bigger than the gem stone to allow for shrinkage.
How do you set stones in metal clay after firing?
Setting stones in metal clay after firing To create a bezel setting in metal clay without damaging the stone, use a fine bezel wire and solder it into the bezel as normal.
How do you make a ring out of precious metal clay?
How To Make A PMC Ring
- Measure out the size of your PMC ring.
- Add 15% to your original measurement.
- Roll out your precious metal clay.
- Cut the clay.
- Leave your ring to dry.
- Tidy edges and neaten cut-outs.
- Now you’re ready for the firing process.
- Brush and polish.
Which stones can be fired with metal clay?
Some stones can be set directly into metal clay and fired in place, while others will have to be set after firing using more traditional methods….Some examples of these stones are:
- Amazonite.
- Chrome Diopside.
- Garnets.
- Hematite.
- Labradorite.
- Moonstone.
- Sunstone.
- Peridot.
Can you fire crystals in clay?
Many natural gemstones can be set into metal clay and fired in place. Other gemstones will not survive the heat of a kiln and should be set after firing.
How do you use silver metal clay?
SO, HOW DOES SILVER CLAY WORK?
- Step 1- Roll out the clay. Keep the clay 1mm thick by rolling it out in between spacers or playing cards.
- Step 2 – Create the shape. Shape and refine your design, using a cookie cutter.
- Step 2 – Create the shape.
- Step 3 – Fire and polish.
- Step 3 – Fire and polish.
What is silver clay?
Silver clay is a material, invented in the 1990s, made up of fine silver particles (usually recycled from the photographic industry and from X-rays), an organic binder and water. The clay can be moulded, rolled, textured and shaped. There are two types of silver clay, 999 fine silver and 925 sterling silver.
Can you make rings with metal clay?
Making a ring from metal clay may seem a little intimidating at first, but it’s actually very easy. I’ll go over the tools you’ll need along with some options, and give you some good ring building techniques to get you started. A finger gauge is used to determine ring size.
How do you embed bezel wire in metal clay?
Tips for Embedding Commercial Bezel Wire into Metal Clay Bezel wire should be wide enough to hold the stone in place securely after burnishing plus another 1 mm in width (i.e., height) that will be embedded in the metal clay. Scuff, scribe or coarsely sand to roughen the 1 mm edge of the wire that will be embedded.
How do you clean the back of a clay bezel?
Drill a hole through the dry metal clay piece to allow access to the back of the stone for cleaning. Moisten the surface of the clay around the hole and on the back of the bezel. Center the bezel-set stone over the drilled hole and press it down firmly, wiggling it slightly until the clay grabs and the bezel won’t move.
How do you embed a faceted stone in clay?
When embedding a faceted stone in fresh metal clay, getting the table of the stone perfectly level and the girdle recessed to the correct depth can be a challenge. The easiest way is to moisten the hole in the fresh bezel or backplate, wait a few moments and lightly oil the moistened surface.
How to set clay with alternate coil setting?
Alternate Coil Setting Method 1 Moisten the area of the moist clay design where you want to set the stone. 2 Press the stone into the clay so the girdle is flush with the surface. 3 Add a line of syringe to the clay directly around the stone to cover the girdle.
